Igloos built 300 km north of Arctic Circle - Finland

Use this forum for posting and viewing igloo photo's
Post Reply
Remco
Posts: 1
Joined: Sun Nov 15, 2009 9:30 am
AntiSpam: Igloo

Igloos built 300 km north of Arctic Circle - Finland

Post by Remco » Fri Apr 02, 2010 6:34 am

We built two igloos on two consecutive nights in Arctic Lapland last week. Due to the sugar-consistency snow an 11-foot igloo took us 6 hours (getting to the fourth layer when we gave up). The second, 8-foot igloo took us 8 hours to complete. Reason: 4 feet of granulated-sugar consistency powder snow that refused to set into the Icebox. Only way to build blocks: press the snow hard and let each individual block set in the Icebox for 10 minutes, before moving on to the next block.

Frustrating, but eventually rewarding...
Attachments
IMG_3861.JPG
The unfinished result in the morning. Two of us crawled in and slept under the domeless dome regardless
IMG_3792.JPG
More Northern Lights over the construction site. It is now 11pm. Should we give up or keep going?
IMG_3783.JPG
Four layers of the 11-foot igloo under the bright Northern Lights
IMG_3764.JPG
Aurora Borealis lights the side of our igloo-under-construction
IMG_3698.JPG
Some blocks already break inside the box... but giving up is not an option!
IMG_3690.JPG
Starting with the base layers of our 11-foot igloo...
EF_Nellim_Mar10_623_kl.jpg
8-foot igloo, the morning after the night before...

User avatar
Igloo Ed
Posts: 336
Joined: Fri Feb 29, 2008 1:44 pm
Location: Lyons, Colorado
Contact:

Re: Igloos built 300 km north of Arctic Circle - Finland

Post by Igloo Ed » Thu Apr 08, 2010 9:27 am

Some beautiful pictures. It has been a long time since I've lived at northern latitudes and seen the Aurora Borealis. I miss them.
The igloos look good too and I hope the unfinished 11 ft. igloo protected you from the wind.
By looking at the clothes you are wearing I would guess it was not real cold and the snow should have worked. I have built at -27f. with old/granular snow in Yellowstone. It takes me just over two minutes to build a block in those conditions.
I can see a few problems in your pictures. The fifth picture shows the Toggle Handle on the bottom of the pole. It must be on top of the pole so it will stay engaged while packing. The fifth picture also shows snow against the form and the snow must be removed before moving the form so it moves freely.
The sixth picture shows the block being packed while the Toggle Handle is being held closed. The form must be steadied with the left hand on the End Panel so it doesn't move. The form cannot move when packing, not even a tiny bit. The packing must be gentle to stop the form from moving and the left hand must be very steady (ridged) to hold the form from moving. If the form moves, the block is broken and that is why you had to wait 10 minutes for the block to sinter.
I would also suspect that you stake was coming loose or moving if you were packing hard. If the stake moves, you will have interferences when you move the form and the block will break when moving the form.
How I wish I could teach you in person.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest